Page 3 of 3

Re: P600 0x53 Error

Posted: Thu Apr 13, 2017 2:21 pm
by sonyoasis
Hey t-dozer runs in sheet mode i will have a look into error 53 for you . 

Re: P600 0x53 Error

Posted: Thu Apr 13, 2017 3:32 pm
by sonyoasis
Where have you mounted the ASF relay board? In The T-dozer conversion videos Jeff says to mount it on a metal lug which used to hold the ASF unit . Way back when i did my first t-dozer build i had a problem with that location. The printer would throw up an error, after removing it from that metal lug the printer would boot up. Unfortunately i cant remember if it it was error 53 but worth a try first. 

Re: P600 0x53 Error

Posted: Sun Apr 16, 2017 4:48 am
by tjello
Its not possible to use a different motor and different pulley with the t-dozer is it?

Re: P600 0x53 Error

Posted: Fri Apr 21, 2017 4:06 am
by sonyoasis
I think it would require a code change to use a different set up as the timings would be off? If its a new T-Dozer stepper motor you are after PM me and i can send you a link on where to get it.