You need to connect pin 6 to 1 side of your toggle switch and the other side to Arduino ground. The switch 1 way gives you 1 pass and the other way is 2 pass.putba wrote:I just need a toggle switch or button is also necessary for automatic 2 phase? is pin 7 in arduino connected to a toggle switch or where? where cable pin 7 in arduino should connect? What cable must be connected in toggle switch?
I connected the pin 7 arduino to toggle switch but Platten not backwards after the first phase print. what is wrong andy? thanks
Those are the right files. What is the error?Bluemb wrote:Hello to all,
I am not very practical arduino but I thoroughly studied the Epson printer R1900 / R2000
I'm trying to upload the file DIY_DTG_R3000_P600_BUILD_00005
the liberira Bounc2-master.zip
on a ARDUINO MEGA tells me a row of mistakes someone tells me if I'm wrong file pair
Did you try the same thing in the other toggle position? It's hard to tell without knowing your buildputba wrote:I connected the pin 6 to toggle switch, I set up the printer to print two copies and toggle switch in the on position but after the first print phase, Platten not backwards and just sitting in the front of the printer blinking. where lies his error?