Page 1 of 1

Finished R3000 Print Module

Posted: Tue Mar 07, 2017 1:44 pm
by Andy
I finished up my covers for the R3000 AIO print module I've been testing with. Added quick disconnect motor and limit switch wires and built a USB port into the back cover that's connected to the AiO USB. 

In the future I will be adding more pictures and videos to showcase what is possible with the OpenDTG.

Re: Finished R3000 Print Module

Posted: Tue Mar 07, 2017 2:51 pm
by shabby
Clean

Re: Finished R3000 Print Module

Posted: Tue Mar 07, 2017 2:55 pm
by Watchhead
Very impressive.

Re: Finished R3000 Print Module

Posted: Mon Mar 13, 2017 1:02 pm
by UVDTG
Did you use an off-the-shelf USB-B extender? 

Are you going to make more/sell those panels for the inside of the printer? 

Edit: I really like how clean it came out :D

Re: Finished R3000 Print Module

Posted: Mon Mar 13, 2017 3:24 pm
by Andy
UVDTG wrote:Did you use an off-the-shelf USB-B extender? 

Are you going to make more/sell those panels for the inside of the printer? 

Edit: I really like how clean it came out :D
Yes I just got a usb to usb panel mount. 
I could sell the covers, I wasn't sure if DIY people would go that far with their builds. 

Re: Finished R3000 Print Module

Posted: Tue Apr 25, 2017 6:26 pm
by ScottB724
If there were a like button I'd like it 1,000 times 

Re: Finished R3000 Print Module

Posted: Fri Jul 28, 2017 1:16 pm
by brandonholcomb
Very clean. 

Re: Finished R3000 Print Module

Posted: Thu Aug 03, 2017 8:28 am
by CyrusP
That is so nice, congrats!