By alkozy - Mon Jan 23, 2017 4:52 am
- Mon Jan 23, 2017 4:52 am #3409
You really think that can be the problem of motor trembling? I am also testing this wiring and have the same problem. You know it does not matter if platen or finger pushes limit switch I think. It should just stop, not talking about platen returning to the front when there is short delay while platen unclick limit switch.Andy wrote:It is supposed to hit the back switch and then slowly come forward until it is released.alex24bog wrote:when press the limit switch ,,,the steeper motor tremble ...no stop,,,arduino p008....nema 17 ...tbs6600 ...printer scp600..thanks
Make sure you are testing with a fully built system so everything is triggered properly. When doing it by hand it won't be the exact same as the platen moving like it is supposed to.