The downloads in this section are restricted to forum paid members and customers.

To gain access you can buy a lifetime membership here: shop/index.php?route=product/product&pa ... duct_id=77

Or you can purchase an OpenDTG shield or controller board. If you've made a purchase and need access contact info@opendtg.com
#3883
OpenDTG AIO v1

Build 00003

Requires bounce2 and encoder libraries to be installed in Arduino IDE.

NOTE: ONLY use this code as is with the OpenDTG AIO V1 controller board. This code relies on hardware that protects the Epson from voltages greater than 3.3v. We are not responsible to any damage to your Epson printer. Use at your own risk.
You do not have the required permissions to view the files attached to this post.
#3884
Build 00005

- This update adds support for the OpenDTG Desktop app. You are able to use physical buttons, the desktop app or both to control your platen.

Requires bounce2 and encoder libraries to be installed in Arduino IDE.

NOTE: ONLY use this code as is with the OpenDTG AIO V1 controller board. This code relies on hardware that protects the Epson from voltages greater than 3.3v. We are not responsible to any damage to your Epson printer. Use at your own risk.
You do not have the required permissions to view the files attached to this post.
#3885
Build 00006

-  Added code to slow down the platen before it hits back limit switch and front maxSteps.

Requires bounce2 and encoder libraries to be installed in Arduino IDE.

NOTE: ONLY use this code as is with the OpenDTG AIO V1 controller board. This code relies on hardware that protects the Epson from voltages greater than 3.3v. We are not responsible to any damage to your Epson printer. Use at your own risk.
You do not have the required permissions to view the files attached to this post.