Show off your tshirt printer and flatbed UV printer builds and modifications
User avatar
By Andy
#4216
I finished up my covers for the R3000 AIO print module I've been testing with. Added quick disconnect motor and limit switch wires and built a USB port into the back cover that's connected to the AiO USB. 

In the future I will be adding more pictures and videos to showcase what is possible with the OpenDTG.
You do not have the required permissions to view the files attached to this post.
iuliusdobre liked this
By UVDTG
#4343
Did you use an off-the-shelf USB-B extender? 

Are you going to make more/sell those panels for the inside of the printer? 

Edit: I really like how clean it came out :D
User avatar
By Andy
#4349
UVDTG wrote:Did you use an off-the-shelf USB-B extender? 

Are you going to make more/sell those panels for the inside of the printer? 

Edit: I really like how clean it came out :D
Yes I just got a usb to usb panel mount. 
I could sell the covers, I wasn't sure if DIY people would go that far with their builds.